Banana to 3.5mm Minijack Cable Kit

cables_1500x1500.png
onlycables.png
groundcable.png
cables_1500x1500.png
onlycables.png
groundcable.png

Banana to 3.5mm Minijack Cable Kit

39.99

This kit allows you to connect PHENOL to analog gear that use 3.5mm connectors for control voltages.

Contents:
4 x banana to 3.5mm minijack adapter cable (3 ft.)
1 x 3.5mm to 3.5mm patch cord (grounding cable) (6 ft.)
1 x 3.5mm to 1/4" adapter

Quantity:
Add To Cart

WARNING: PHENOL must be grounded to the other system at ALL TIMES when banana cables are connected between the systems. Always install the ground cable first and remove it last.

Install the ground cable:

The ground cable is supplied as a 3.5mm to 3.5mm cable plus a 1/4" adapter. Normally this would be connected to a spare 1/4" connector on the back of PHENOL. We recommend using an unused EXT IN jack. Connect the other end to an unused jack on your other system.

Note that the rear panel banana ground jack is not used with this kit. Do not use the supplied banana to minijack cables for grounding.

Connect the 3.5mm Minijack to Banana cables:

Once the ground cable is install you can freely patch between any banana jack on PHENOL and jacks on your other system.

The voltages used by PHENOL are compatible with most Eurorack-like systems. Some patches may not produce the expected results. Experiment and ask on forums for advice if necessary. Kilpatrick Audio can offer general assistance but cannot answer questions about specific 3rd-party products.